Thetford Corp 36662 RV Marine Fresh Water Sanitizer Kit
Thetford Corp 36662 RV Marine Fresh Water Sanitizer Kit
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume.
For product availability, please text (855) 432-6357 with the vendor number and quantity you are looking for. We will answer ASAP.
The Thetford Corp 36662 RV Marine Fresh Water Sanitizer Kit kills 99.99% of harmful bacteria in 60 seconds. It is the first and only sanitizer specifically designed for the entire fresh water plumbing system of RVs and boats. The two-step process included in this kit will clean and sanitize a 96-gallon RV water tank. It is designed specifically to sanitize hard non-porous surfaces of water holding tanks in RVs, trailers, campers and boats. We recommend this product for use at the start the season and after the vehicle sits for any length of time. It can also be used on remote tanks, water coolers and hoses, and is EPA registered in all 50 states. Safe for aluminum and stainless steel!
Product Features
- Easy-to-Use 2-Part System
- Step 1: Clean tank with detergent and rinse
- Step 2: Sanitize tank with sanitizer
- Effective even in hard water
- Will not leave grit or soap scum
- Not a drinking water additive
Additional Information
Directions For Use
Instructions - STEP 1 - Cleaning
1. Empty tank and add 1 ounce of concentrated detergent solution to the fresh water tank for every 4 gallons of tank capacity. (For a 40-gallon fresh water tank, add 10 fl oz of detergent)
2. Fill tank with water. Run diluted Detergent Solution through each faucet, shower and water outlet for approximately 1 minute.
3. Empty the tank.
4. Flush the tank and faucet lines by filling with clean water, running water through the lines and draining.
IMPORTANT TIPS FOR USE:
Use the markings on the label for measuring the proper dilutions. When there is no direct opening in the tank, solutions can be added to the tank through a water filter canister (with filter removed) or by pouring solution into a hose and connecting hose to the external water inlet.
Instructions - STEP 2 - Fresh Water Tank Sanitizer
Sanitization of interior hard non-porous surfaces of water holding tanks - sanitization should occur after initial installation, after the system is serviced and periodically during its use.
1. Shut off incoming water line.
2. Units/tanks must be washed with a compatible detergent (enclosed) and rinsed with potable water before sanitizing.
3. Prepare a solution of 2 ounces of product per 8 gallons of water (200 ppm active quaternary).
4. Apply or circulate (if possible) to wet all surfaces and allow a minimum contact of 60 seconds.
5. Drain the unit.
6. Return to service by opening incoming water lines.
Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
