KTI KWR-003 Wireless Dump Trailer Controller
KTI KWR-003 Wireless Dump Trailer Controller
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume.
For product availability, please text (855) 432-6357 with the vendor number and quantity you are looking for. We will answer ASAP.
This listing is for one KTI KWR-003 Wireless Dump Trailer Controller.
This wireless remote control works with any trailer built after January 2015. Very simple and quick installation. The wireless remote has a range of about 40ft with no obstructions. Reciever has a built-in safety – shuts down after being idle for 20 minutes. Receiver has the abilty to program up to 4 key fobs to one receiver. Includes a inline 15 amp fuse on the power wire for protection 5/16″ eyes are included on power and ground wires to ease installation to battery. Receiver Power and Ground Wire lengths: 24″. 2 Button receptacle connector wire length: 14″. 2 Button power unit connector wire length: 32″. Detachable antenna has a 38″ wire.
Compatible only with KTI Applications!
KTI KWR-003 is no longer being produced. Limited quantities available.
It has been replaced by KTI KWR-005 Bluetooth Wireless Dump Trailer Controller
Kit includes:
- (1) Main Transmitter
- (1) 23 AE Battery (for transmitter)
- (1) Main Receiver Unit
- (1) Detachable antenna
- (1) Antenna mounting screw
- (2) 2″ by 2″ velcro
- (1) Installation Manual
*Wireless Remote Comes Preprogrammed*
- Mount Wireless Receiver.
- Select desired mounting location preferably in a sealed box and out of harm’s way.
- Antenna must be mounted outside, not in metal box.
- Connect Pin Connector to Power Unit. (Fig. 1)
- Connect positive (Red Wire) & negative (Black Wire) ring terminal to Hydraulic Power Units. (Fig. 1)
- Connect (+) Red wire to the same terminal on Start Solenoid as positive cable from the battery.
- Connect (-) Black wire to motor housing or to negative terminal on the 2 terminal DC motor.
Note: Insure the Power Unit is grounded directly to the negative terminal on the battery, which is the designated grounding location.
- Operate Wireless Unit and Remote Pendant to insure proper functionality.
- Up Button or OUT
- Down Button or IN
- Connect Remote Pendant to Receptacle Connector on Wireless Receiver. (Fig. 1)
- To turn power ON or OFF, press both buttons Up and Dn simultaneously. When the receiver is in OFF mode, the LEDindicator will not illuminate. When the receiver in ON, the LED indicator will flash GREEN every 3 seconds to show that the receiver is connected to a power source above 9 Volts. If the power source is below 9 Volts the LED indicator will flash RED every 3 seconds.
- When receiver is ON, press any button on key fob, the LED on receiver stays ON, LED light cuts off when release button.
- 20 Minute Shut-down Mode (Receiver shuts down after being idle for 20 minutes).
- Press both buttons (Up & Dn) to turn the receiver ON.
- In Shutdown Mode; (Output 2) the Remote Pendant) is still active. (Fig. 1)
Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
