Campbell RVDH-34 Inline RV Water Filter (Includes 12 Inch Hose)

The Campbell RVDH-34 Inline RV Water Filter with Hose is designed to remove unpleasant tastes and odors from potable drinking water. This rv water filter accepts standard hose fittings making it easy to install to campers, trailers, motor homes, and boats. Includes filter and plastic protective caps.

Product Specifications

• Part Number: RVDH-34
• Overall Length: 10 Inches
• Flow Rate: 3 Gallons Per Minute
• Uses standard 3/4” hose
• Pressure Range: 30-125 PSI
• Temperature Range: 40-100 Degrees Fahrenheit

Click Here To See The Comparison Chart of All Campbell RV Water Filters

RV Water Filter FAQ

1. Why does my water look gray after I change my rv water filter?
This is a common occurrence after changing a carbon filter and is caused by fine carbon dust being flushed out of the cartridge. It will be gone after you run a few gallons of water through the unit.

2. When should I change my rv water filter?
There are two primary indicators that will alert you to replace a filter cartridge. The first indicator is a reduction in flow rate, which is caused by a filter getting plugged with sediment. The second indicator is a little less obvious and involves your taste-and-odor rv water filter. If you notice that the taste and/or odor of your water is not as clean as it used to be, it is very likely that your carbon rv water filter is losing its effectiveness and needs to be replaced. This assumes that you have a carbon filter. 

4. Why should I filter all the water going into my RV, including the water for the toilet?
Many plumbing fixtures, both in homes and RVs, have small orifices and moving parts that come in contact with the water. Sediment and sand can wreak havoc in these fixtures, and removing the sediment is often much cheaper than repairing a plugged or damaged fixture. RV parks can have a real load of sand and sediment in the water.

5. Why would I need a double-canister filter setup?
There are two primary tasks that you'll want your filtration system to perform: remove sediment and improve the taste and odor of the water. While it is possible to do both with one rv water filter, you'll get better performance if you utilize separate water filters for each of these tasks.

6. Do rv water filter canisters need to be upright to work properly?
No, they can be mounted in any position you want. However, cartridges containing granular carbon may have a problem if not upright. Granular carbon is subject to "channeling" in which the water forms small channels that enable it to bypass the carbon. This condition seems to occur more when these cartridges are not upright.

7. Why can't I have a clear canister as one of my two in a dual-canister rv water filter system?
You can, of course, and we sell them that way. However, if you are planning to set up your canisters outside your RV where a lot of light will be available, we don't recommend you use a clear canister. The reason for this is that the light will promote algae growth, which will prematurely plug up your filter. If you want to include a clear canister, you should place it somewhere that is protected from light such as a bay or under the sink.

 

Prop. 65 Warning for California Residents

WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.